Property Controls - Schlage

This page and all others on the help site will be retired in Q4 2024. Please refer to the new help site by clicking the Help icon in the top-right corner of the STRATIS Management application.

This menu is used to control thermostat set points across your property.

Set Thermostat Setpoint Limits on Heating and Cooling in Occupied Units

Thermostat Setpoint Limits allows you to set minimum and maximum ranges for heating, cooling, or both.

Select Devices, then Property Controls.
Select General.
To enable setpoint limits, activate the Off / On toggle for Thermostat Heat, Thermostat Cool, or both.

The first time you activate the toggle to On, default values of 55-78 (heat) and 63-85 (cool) are populated in the columns for Min and Max Values.

Enter your desired limits in the Min Value and Max Value columns. Keep in mind the range of allowed values:
1. The Min Value can be set from 0 - 120 degrees.
2. The Max Value can be set from 40 - 120 degrees.

Set Property-Wide Thermostat Controls for Common Areas and Vacant Units

This setting sets property temperature once, then assumes that this is the setting you’d like to have for ongoing temperature. To change temperature settings in future, you’ll need to select Set Temp again to trigger this menu and your temperature change.

Select Devices, then Property Controls.
Select Thermostats.
Select a thermostat mode, then Confirm in the window that pops up.
Adjust the thermostat set point by clicking either + or -.
- To adjust settings in Auto, select the temperature to adjust before tapping + or -.
Select Set Temp and confirm the changes.